Your On-Line Port'o'Call

Previous Thread
Next Thread
Print Thread
Rate This Thread
#569001 - 08/31/17 09:01 PM Winterizing Checklist  
Joined: Mar 2004
Posts: 4,204
Puddle Pirate 2 Offline
LTJG USCGR
Puddle Pirate 2  Offline
LTJG USCGR
Admiral

Joined: Mar 2004
Posts: 4,204
Eastern PA
Found this the other day from my old computer. It is for a 2000 Maxum 1900, but I thought I might post it in case it could help someone with a similar setup. I'd also appreciate feedback in case anything is missing so I have a more updated list for my next boat. Of course, not all boats are the same:

BOAT WINTERIZING CHECKLIST:

1. TREAT GAS: Put StaBil in fuel tank, either before refilling, or before trailering or using the boat.
2. CHANGE ENGINE OIL: Run engine on muffs or with the boat on the water (preferably) for about 10 minutes minimum (do not run too long on muffs) to heat up oil. Oil will get hotter if you run on the water, and will stay hot for over an hour.
3. Pump out old oil, spin off old oil filter, and install new oil filter. Fill with fresh oil.
4. FOG ENGINE: Spin off old fuel filter and drain out gas. Fill old fuel filter with a 50/50 mix of 2-cycle oil and gas, or 50/50 mix of 2-cycle and fuel injector cleaner. Spin on old filter, being sure not to spill any mixture in bilge.
5. Run engine on muffs at medium idle (about 1000rpm) until it stalls. If it almost stalls, but then returns to normal idle, you have used up all the fogging mixture, and will need to re-do step 4. Run at a lower idle and/or use more 2-cycle oil if this happens. The engine MUST stall for this to work. (This step will also coat everything with fresh oil from step 3).
6. As an optional step, you can remove the spark plugs and spray fogging oil in each cylinder. This is usually not necessary, is very difficult (requires a mirror to see what you’re doing, and knuckle attachments to get the plugs out), and isn’t required by Mercruiser.
7. Remove old fuel filter and install new one.
8. DRAIN BLOCK: This is the most important step!!!! Unscrew all 6 blue plastic plugs on the engine. There will be 1 on either exhaust riser, 1 on each side of the block, one on the power steering cooler on the port side bottom, and 1 on the water pump. Use a coat hanger or wire to clear any blockages. Reinstall blue plugs finger tight, making sure black O-rings are on.
9. Remove Thermostat housing and pour antifreeze in opening (you may want to remove hoses). Cleam off old gasket material and reinstall new T-stat housing gasket (and Thermostat if it is old), and install T-stat housing. Use new lock washers, and torque to 30 ft. lbs. Make sure there is no water in the screw holes. Don’t forget to install U-shaped engine lift ring.
10. DRAIN/REFILL DRIVE: unscrew screw at base of drive on “bullet”. Catch old oil in pan. Unscrew screw at top of drive on port side. Remove any metal filings from screws (they are magnetic)
11. After all oil has drained, install drive oil pump in bottom hole, and begin pumping in new oil. OIL MUST BE PUMPED IN FROM BOTTOM!! When oil begins to come out upper hole, install upper screw with new washer and continue pumping until reservoir is full.
12. Remove drive oil pump from lower hole, and quickly install screw with new gasket.
13. Do not run engine unless you want to re-fog, but be sure to keep an eye on fluid levels next season, and top off as necessary.
14. LUBE GREASE POINTS: Pump grease in all zerks, including drive coupler (VERY hard to reach).
15. OIL ENGINE: Spray fogging oil, CRC or engine oil on engine and linkages. Spray any metal parts with CRC (snaps, wiring harnesses, fishing gear, etc)
16. Remove battery and store properly. Charge about once a month thru the winter.
17. CLEAN BOAT: Wash and wax boat. Remove carpeting and any items that could hold moisture, set cushions ajar to promote air circulation. Place dryer sheets about boat to discourage mice. Remove any items that could be damaged by cold. Remove all battery powered devices (cell phones, VHF, etc).
18. Cover boat and secure straps.
19. WINTERIZE TRAILER: top off tires with air, grease bearings (inspect and repack if you want…not required with Bearing Buddys). Spray any rusty areas with instant galvanizer, spray electrical connections with CRC, change out brake fluid, cover actuator with garbage bag or canvas to keep water out of reservoir. Spray tire dressing on all tires. Optionally, jack up trailer to get weight off springs and tires.
20. Have a beer 


pirate
#569005 - 09/01/17 02:01 AM Re: Winterizing Checklist [Re: Puddle Pirate 2]  
Joined: Jan 2003
Posts: 3,669
Jack T Offline
Admiral
Jack T  Offline
Admiral

Joined: Jan 2003
Posts: 3,669
Southern California
PP:
That is quite a list. I know that the mechanics at our mountain lake use much the same processes you have identified. But, that is one reason that I do not trust what they do. I know, I get comments like "We've always done it this way and have never had problems." They can probably say that because of a multitude of reasons, but problems they may cause may not appear for a long time.

Therefor, I believe it is proper to say that as engine/mechanical technology continues to be more technical, generic actions that used to be good across the board may not be correct for newer models, even within a particular manufacturer's product line. For example, VP uses a much different method to fog the engine on my 2012 engine. This may because it has multi-port fuel injection or maybe because it has catalytic converters.

Therefore, If one were to use a check list, it might prudent to create his own list, but use only the main topics you have included. Then, fill in the details for each topic by including the exact procedures for that boat/motor as they are included in the owner's manual. Check list--excellent idea!


Have a great day of boating
2012 Monterey 224 FS,
300 HP Volvo Penta with catalytic converters

#569006 - 09/01/17 05:09 AM Re: Winterizing Checklist [Re: Jack T]  
Joined: Mar 2004
Posts: 4,204
Puddle Pirate 2 Offline
LTJG USCGR
Puddle Pirate 2  Offline
LTJG USCGR
Admiral

Joined: Mar 2004
Posts: 4,204
Eastern PA
Yes, my intent was to offer one type of procedure, and have others tailor it to their particular engine and vessel. I'll add the disclaimer PLEASE CHECK WITH YOUR MANUFACTURER on exact procedures for your make and model. Even if one has a mechanic or the marina winterize, it's always good to check their work. I live by the motto "trust, but verify".

Offhand, I had the Merc 4.3 TBI with Alpha 1 Gen 2. And it's been a while since I had that boat, so I'm sure things have changed. Hopefully, that will change soon too. We're immersed in looking at late season offerings in pre owned cruisers.


pirate
#569007 - 09/01/17 07:47 AM Re: Winterizing Checklist [Re: Puddle Pirate 2]  
Joined: Aug 2005
Posts: 2,245
tpenfield Offline
Admiral
tpenfield  Offline
Admiral

Joined: Aug 2005
Posts: 2,245
Cape Cod, MA
Yea, that list is too long for me to read smile

Many folks, after doing a few winterizations come up with their own twists to a common theme. The whole idea is to prevent freeze damage and provide extra lubrication to engine components.

I have full closed cooling systems, sea water strainers and MPI engines, so my procedure is rather unique.

I think just about everyone's process includes #20 smile


Regards, Ted

Formula 330SS

My Boat Web Sites
#569106 - 09/11/17 09:07 PM Re: Winterizing Checklist [Re: Puddle Pirate 2]  
Joined: Jan 2003
Posts: 1,476
Lou C Offline
Admiral
Lou C  Offline
Admiral

Joined: Jan 2003
Posts: 1,476
Long Island NY
A very good list, it is long to read eh Ted?
One thing I'd add for people with outdrive boats, is that the drive should be removed each season so you can check for water in the driveshaft bellows and grease the gimble bearing, u joints and driveshaft splines (some newer boats have permenantly lubed gimbles and u joints). This one job will help you avoid expensive repairs due to water in the bellows. I think a lot of people and mechanics skip this till there is a problem....


88 Four Winns 200 Horizon 4.3 OMC
98 Jeep Grand Cherokee 4.0 Six Selectrac
07 Jeep Grand Cherokee 5.7 HEMI Quadradrive II
#569111 - 09/11/17 10:56 PM Re: Winterizing Checklist [Re: Puddle Pirate 2]  
Joined: Jan 2003
Posts: 3,669
Jack T Offline
Admiral
Jack T  Offline
Admiral

Joined: Jan 2003
Posts: 3,669
Southern California
And, while in storage, always keep the drive down to reduce stress on the bellows. At least that is what I have heard and follow religiously. On a lift, you may need to leave it a bit elevated to keep the skeg out of the water--maybe that isn't really necessary, but.......


Have a great day of boating
2012 Monterey 224 FS,
300 HP Volvo Penta with catalytic converters

#569113 - 09/11/17 11:12 PM Re: Winterizing Checklist [Re: Puddle Pirate 2]  
Joined: Jan 2003
Posts: 1,476
Lou C Offline
Admiral
Lou C  Offline
Admiral

Joined: Jan 2003
Posts: 1,476
Long Island NY
That is true, I made the one on my Cobra last 11 seasons here in salt water land by keeping the drive down.


88 Four Winns 200 Horizon 4.3 OMC
98 Jeep Grand Cherokee 4.0 Six Selectrac
07 Jeep Grand Cherokee 5.7 HEMI Quadradrive II
#569118 - 09/12/17 08:44 AM Re: Winterizing Checklist [Re: Puddle Pirate 2]  
Joined: Mar 2004
Posts: 4,204
Puddle Pirate 2 Offline
LTJG USCGR
Puddle Pirate 2  Offline
LTJG USCGR
Admiral

Joined: Mar 2004
Posts: 4,204
Eastern PA
Good point about the bellows. I used to keep mine down except for trailering. Never removed the drive, as the final and splines could be greased through zerks no but I knew so.e guys who removed the lower unit for security


pirate
#569119 - 09/12/17 10:03 AM Re: Winterizing Checklist [Re: Puddle Pirate 2]  
Joined: Jan 2003
Posts: 3,669
Jack T Offline
Admiral
Jack T  Offline
Admiral

Joined: Jan 2003
Posts: 3,669
Southern California
"no but I knew so.e guys who removed the lower unit for security"

??


Have a great day of boating
2012 Monterey 224 FS,
300 HP Volvo Penta with catalytic converters

#569130 - 09/12/17 03:38 PM Re: Winterizing Checklist [Re: Puddle Pirate 2]  
Joined: Oct 2003
Posts: 7,139
captkevin Offline
Admiral
captkevin  Offline
Admiral

Joined: Oct 2003
Posts: 7,139
Chicago, IL
Can't steal what isn't there.


2004 Rinker 232
2010 Dodge Ram Crew Cab Laramie 4x4
#569133 - 09/12/17 08:42 PM Re: Winterizing Checklist [Re: Puddle Pirate 2]  
Joined: Jan 2003
Posts: 3,669
Jack T Offline
Admiral
Jack T  Offline
Admiral

Joined: Jan 2003
Posts: 3,669
Southern California
Thanks Kevin. Is that some kind of secret code or something? (:-)


Have a great day of boating
2012 Monterey 224 FS,
300 HP Volvo Penta with catalytic converters


Moderated by  Admin 

Sponsors
New Topics
Got towed in today motor killed twice
by wijeff. 09/17/17 07:12 PM
Rinker Boats
by Lemar14. 09/14/17 06:30 AM
Active Captain-Do You Belong?
by GoFirstClass. 09/13/17 11:36 PM
It seems like forever........
by GoFirstClass. 09/11/17 11:21 PM
Gas sheen after startup
by swopo82. 09/11/17 12:25 PM
Did you miss me?
by GoFirstClass. 09/10/17 09:50 PM
Back in the trailer boat world...
by Wet Doggg. 09/06/17 12:22 PM
Spider repellent
by Puddle Pirate 2. 09/05/17 12:40 PM
Where to fish in Pennsylvania
by Just Bob. 09/01/17 10:23 AM
Winterizing Checklist
by Puddle Pirate 2. 08/31/17 09:01 PM
Who's Online Now
0 registered members (), 118 guests, and 4 spiders.
Key: Admin, Global Mod, Mod
Newest Members
Lemar14, Windig89, GaryDoug, Rosco_P_Coletrane, jjacobs
5424 Registered Users
Forum Statistics
Forums23
Topics37,034
Posts560,584
Members5,424
Most Online252
Aug 5th, 2017
Powered by UBB.threads™ PHP Forum Software 7.6.0